PDA

View Full Version : TR2/3/3A TR3 Scuttle Panel



oxendine
12-08-2009, 08:38 PM
Since I can't seem to post anything in the wanted section I'll try here. I am in need of a scuttle panel or perhaps just the right hand side for my 1960 Tr3a. Mine has been shoved in and is not repairable. Anyone ever tried to make a piece to weld in?

Thanks, Donnie

tinman58
12-08-2009, 08:56 PM
Post a photo of what you need to do and you will get lots-0-help.

tinman58
12-08-2009, 08:56 PM
P.S. Welcome to the forum Donnie!!!

TR4nut
12-08-2009, 08:57 PM
Donnie-

Welcome to the board. There's a decent chance you can get a patch piece from someone on this board if the timing is right. Like Dan said, if you can post a picture of what you are looking at it will help a lot. Unfortunately I hate to admit it but I put a sawzall to the rusty 60 tub I had and took it to the dump just a week ago. Sorry about that.

Randy

TR3driver
12-08-2009, 09:09 PM
Is your car before or after TS60K ?

I'm planning to dispose of the tub & frame from TS39781LO before New Years ... had hoped that someone would take away (and use) most of it, but so far the response has been underwhelming. However, it likely won't be much help if you are working on the later body style, too many small differences.

tdskip
12-08-2009, 09:11 PM
Hi Donnie - do you want me to proceed on checking out the one we discussed via email?

Welcome BTW - this is a great forum.

Andrew Mace
12-08-2009, 09:16 PM
I might just have what you need. As Dan says, though, a picture of the area you need -- and possibly some measurements -- would be a big help! My SawzAll stands ready to help! :wink:

M_Pied_Lourd
12-08-2009, 09:31 PM
I have a spare tub as well, post 60000 if it helps.

Cheers,
M. Pied Lourd

oxendine
12-09-2009, 07:17 PM
Yes, please do.