PDA

View Full Version : TR2/3/3A TR 3A Sill Edge Finisher Set



Tinkerman
07-02-2009, 07:12 AM
The Moss Catalog shows a Sill Edge Finisher set in Aluminum page 70 item 18, in the catalog I have. I can't find it in the StanParts book. Where does it go and how does it mount? Pictures would be great!

All thoughts on this greatly appreciated.


thanks, Tinkerman

DougF
07-02-2009, 08:20 AM
It pulls down over the joint of the inner and outer sills, the long side to the driver's compartment. It is held in place by trim screws.

TR4nut
07-02-2009, 08:50 AM
Dick-

I think those are pn 900428/900429 as seen in TRF as well.

Randy

Don Elliott
07-02-2009, 11:21 AM
Here is the one in my 1958 TR3A. I installed these in 1990 and they still look good. This photo was taken in June 2008. Those are the original screws and I match marked the holes from the original sill plates so they would be in the correct places. I had to trim about 1/8" off all along the bottom where it is hidden anyway by the edging along the side of the carpet.

Tinkerman
07-03-2009, 01:11 PM
Thanks for the help fellows. Don your picture clears it up nicely for me. I found them in the Stanparts catalog with those numbers Randy, thanks.

Tinkerman