PDA

View Full Version : TR6 TR6 Seat belt mounting question



mrv8q
08-30-2008, 02:37 PM
Has anyone tried the TRF kit for seatbelt replacement? These replace the Kangol inertia belts. Here is a pic of the mounting points on the TR6:

https://i125.photobucket.com/albums/p52/mrv8q/IMG_0896.jpg

Here's a pic of what comes in the TRF kit:

https://i125.photobucket.com/albums/p52/mrv8q/IMG_0897.jpg

When I got the car, the original seatbelts were in the trunk. I'm guessing the the short part of the belt goes into the large bolt hole in the floor, inboard of the trans tunnel. That leaves 2 mounting holes on the long belt. I'm guessing the end attaches to the bolt at the bottom of the "B" pillar. The remaining mounting point w/ the plastic cover would go to one of the two mounting points on the rear wheel arch......

Thanks for any help!

tdskip
08-30-2008, 04:34 PM
Too funny Kevin - we're working on the same exact thing....

mrv8q
08-30-2008, 04:51 PM
Tom, I think I figured out the belts; the seats/tracks are a pain in the @#$!&@!

tdskip
08-30-2008, 06:21 PM
What is up with the seat track?