View Full Version : Brosky

06-15-2008, 07:54 AM
Brosky, do you have the stock, stanpart cam you removed from you engine? If so, would you take some measurements?

06-15-2008, 08:44 AM
If Paul doesn't have it, I can dig mine up.


06-15-2008, 10:20 AM
I can get it, but not until Tuesday morning. I think that it's still at Erik's shop, but I'll be out of town tomorrow and not returning until Tuesday to be able to pick it up.

Shannon, can you get your cam out for Searcher?

If not and you can wait, I'll get mine asap.

06-15-2008, 10:28 AM
Thanks, I'd like to have the measurements from the rear edge of the retainer groove, to the front edge of each lobe, including the fuel pump lobe. Please make sure the camshaft you use has stanpart on it.

06-15-2008, 12:38 PM
k. I'll have to dig it out of the garage. I'll do my best to have it you the measurements tonight.

06-16-2008, 10:25 PM
These are dimensions for the Stanpart cam I pulled out of my 73 TR6, plus/minus 0.1" non cumulative

lobe 1 0.5"
lobe 2 2.5"
lobe 3 4.0"
lobe 4 6.0"
lobe 5 7.3"
lobe 6 9.2"
lobe 7 10.8"
lobe 8 12.6"
lobe 9 14.0"
lobe 10 15.8"
fuelpump 16.8"
lobe 11 17.4"
lobe 12 19.5"