View Full Version : Fuel pump blanking plate

02-09-2008, 04:01 PM
Anyone have a part number for this?
istr it's from a BBC.

02-09-2008, 04:07 PM
I used 1 from a speed shop. Their all about the same. Make sure he uses either a gasket or an out of the tube gasket. I probably don't need to tell you this.

02-09-2008, 06:14 PM
Easy to make your own out of 1/4" aluminum. Just cut to rough size then file along the edges. I follow up on my 12" disc samder then lap the edges using 180 grit around a block of hardwood.

Use the gasket as a template.

02-09-2008, 08:39 PM
I got one from Rick Patton when I converted to TBI. You can contact him at info@pattonmachine.com to see if he sells them.

02-12-2008, 08:25 PM
Frank Fisher also makes (& sells) them.