PDA

View Full Version : 180mm or 190mm clutch plate diameter?



BritCarFan
06-08-2007, 03:59 PM
The clutch plate I removed from the engine has a diameter of 180mm. The one in the replacement kit (includes pressure plate and clutch plate) has a diameter of 190 mm while the pressure plate is exactly the same as the one from the engine.

Will it be a problem to install a 190mm plate on an engine which had a 180mm one originally installed?

RonMacPherson
06-10-2007, 02:06 PM
Does the new disc fit without any drag on the trans input shaft, slide easily on the splines?

Does the new disc fit under the pressure plate, not protruding past the outer edge of the plate contact surface anywhere. Does the new disc fit on the machines surface of the flywheel, again without protruding?

If yes on these three, then should be able to use it.