PDA

View Full Version : Fuel Gauge/Voltage Stabilizer



Cain
04-30-2004, 02:17 PM
It is my understanding that the fuel gauge and temp gauge wiring is routed through the voltage stabilizer on the TR6. My temp gauge works, but my fuel gauge doesn't work, and I noticed that the VS on my TR6 has four prongs but only three wires attached. Should I be looking for a fourth wire to attach to the VS?

Rick O.
04-30-2004, 02:30 PM
There should be 3 green (G) wires attached to the "B" post on the stabilizer and only one light green with green tracer (LG/G) attached to the "I" post. The LG/G wire goes first to the temp gauge and then on to the fuel gauge. The green wires run to the washer switch, wiper switch, and a 5-way connector. Since your temp gauge works, I'd check for continuity between it and the fuel gauge. ALso check for continuity in the green with blue tracer (G/B) wire running between the fuel gauge and the sender in the fuel tank.

Hope this helps.

Rick O.