PDA

View Full Version : TR2/3/3A Cross reference for hardware



GilsTR
04-16-2018, 01:58 PM
A number of years back Moss Motors had a TR6 catalog
that had on a reference sheet showing
part numbers and the size of the bolt / nut / washer / screw etc.
While I do not mind buying some hardware from our vendors...
having this handy sheet saved us so much time during the
restoration project. Missing a bolt...you immediately knew the
size....and stopped at the hardware store...found the Grade 8
inventory...and I was on my way.
Somehow in moving the shop from one location to another I
lost this valuable sheet.
Do any of you happen to have a copy of this that you would
be willing to either email or snail mail to me?
Thank you for your consideration.
Gil NoCal

DavidApp
04-16-2018, 03:41 PM
Is this the one you were looking for?

It exceeded the limit on the forum. PM me and I can e mail a copy.

David

GilsTR
04-16-2018, 07:13 PM
David...I do not seem able to get my PM to go thru to you.
Kindly email what you have to me:
Thank you
Gil
gsissons@comcast.net

DavidApp
04-16-2018, 08:30 PM
They came through OK. E mail sent.

I have seen the suggestion on another forum that if you post an e mail address you use (at) not @. People get it Bots don't.

David

GilsTR
04-16-2018, 08:51 PM
I will look for the email
Thank you for the suggestion of email address
Gil

Andrew Mace
04-17-2018, 03:54 PM
You can also access the Standard-Triumph Hardware Catalogue through the Canley Classics web site:

https://www.canleyclassics.com/standard-triumph-hardware-catalogue

M_Pied_Lourd
04-18-2018, 12:29 PM
I also like the back of TRF's TR250/TR6 Glove Box Companion. It has them listed as well.

Cheers
Tush

CJD
04-18-2018, 08:05 PM
You guys are trying to take one facet of the fun out of the restoration. Part of the attraction is using a long bolt to dig through your boxes of old bolts looking for that single bolt you need out of the thousand or so old bolts you have!

DavidApp
04-18-2018, 09:35 PM
Do you go for the Metric, British US screw mix or try to keep it to a single thread type?

David