PDA

View Full Version : TR4/4A Front Wire Wheel Hubs Differ from Disc Hubs??



KVH
01-14-2018, 02:46 PM
Gosh, I sure never noticed. How are the two hubs different? I thought the only difference was the length of the studs.

JerryVV
01-14-2018, 03:12 PM
Only difference is the length of the wheel studs

TR3driver
01-14-2018, 03:46 PM
The hubs came with the studs already installed, so the part number for the assembly is different. But like Jerry said, the hub itself is the same.

JerryVV
01-15-2018, 09:31 AM
The hubs came with the studs already installed, so the part number for the assembly is different. But like Jerry said, the hub itself is the same.
Well that makes sense, you need to remove the rotor and with a good whack the wrong studs come out and then pull the right ones in with a nut and some washers, Bob's your Uncle.

Geo Hahn
01-15-2018, 11:41 AM
...with a good whack the wrong studs come out and then pull the right ones in with a nut and some washers, Bob's your Uncle.

And then you can move on to the rear... and that's a whole 'nuther story.

JerryVV
01-15-2018, 08:34 PM
And then you can move on to the rear... and that's a whole 'nuther story.
If an IRS car they're easier than the fronts, solid axle in your words 'nuther story for sure.