PDA

View Full Version : Terminal and Connector Help



DNK
07-15-2016, 01:21 PM
I'm rewiring the ECU plugs in the Wedge and have gotten stumped on how to remove the terminals out of a Delphi 150.2 connector
43856

Anybody have history with these?

TOC
07-15-2016, 02:16 PM
Yes. I may have the tool still, and probably a bag of connectors.
Rectangular or round?

Been a LOT of years...some you flex the tab down (just visible lower left in your photo), usually have a small flat bar that slides in to release the catch.

Dave

TOC
07-15-2016, 02:18 PM
https://www.waytekwire.com/item/422/REMOVAL-TOOL-METRI-PACK-150-/?gclid=CKqnoJSK9s0CFVBhfgodkG0AzA

DNK
07-15-2016, 02:24 PM
Have all those.
The pull to seat 150.2 is a real bugger.
I can't get the tang to release

TOC
07-15-2016, 02:43 PM
You have to push to release. Then insert the tool while holding connector pin forward. The catch seats in a groove. IF I recall my days on General Misunderstandings. That's why they are called "pull to seat".

DNK
07-16-2016, 05:02 PM
A friend made this for me
https://www.youtube.com/watch?v=MQXz5tBLjgA