Activity Stream

Filter
Sort By Time Show
Recent Recent Popular Popular Anytime Anytime Last 24 Hours Last 24 Hours Last 7 Days Last 7 Days Last 30 Days Last 30 Days All All Photos Photos Forum Forums Articles Articles Blog Blogs
  • poolboy's Avatar
    Today, 07:06 PM
    poolboy replied to a thread TR2/3/3A What does a condenser do? in Triumph
    Nothing as long as you keep it where it is.
    20 replies | 338 view(s)
  • tahoe healey's Avatar
    Today, 06:58 PM
    tahoe healey replied to a thread Engine Stutter in Austin Healey
    The "special" ethanol needles that was to make the mixture richer were probably what made me move the jets up. I'm not too old to learn from my...
    15 replies | 272 view(s)
  • vette's Avatar
    Today, 06:10 PM
    vette replied to a thread Engine Stutter in Austin Healey
    Yea lean carbs will do that. Glad to see you got your needles and jets sorted out. I never have seen an SU carb that could work well with its jets...
    15 replies | 272 view(s)
  • EWD's Avatar
    Today, 05:01 PM
    EWD started a thread TR6 Rear Transmission Seal 74 TR6 in Triumph
    Evening folks - Just read the previous posts re: this topic and need some advice: My interior is out, transmission and driveshaft tunnel covers...
    0 replies | 21 view(s)
  • BJ8Healeys's Avatar
    Today, 04:54 PM
    Posting for a non-BCF member. For sale due to health reasons: HBJ8L/32038, built 31 May - 3 June 1965, owned since 1989. Dual light Phase 2,...
    0 replies | 6 view(s)
  • Boink's Avatar
    Today, 04:47 PM
    Boink replied to a thread Hyper-positive Camber in The Pub
    Boy isn't that the truth. I damaged the muffler on my 100-4 innumerable times.
    13 replies | 330 view(s)
  • John Turney's Avatar
    Today, 04:34 PM
    John Turney replied to a thread Hyper-positive Camber in The Pub
    Hey, our Healeys are the original low-riders!
    13 replies | 330 view(s)
  • OldDad's Avatar
    Today, 04:23 PM
    Thanks all, looking forward to it
    4 replies | 61 view(s)
  • deuce's Avatar
    Today, 04:18 PM
    deuce started a thread TR2/3/3A sealing master cylinder pocket in Triumph
    Hi folks.. What did you use to seal the master cylinder pocket to the firewall? Caulk? Rubber? Thanks
    0 replies | 22 view(s)
  • Madflyer's Avatar
    Today, 04:04 PM
    Madflyer replied to a thread TR2/3/3A Shaking in steering wheel above 50 mph. in Triumph
    First TR 6 wheel do not have pins for hub caps and may be wider. Is the problem the same on all roads? Will it hold straight with hands off the...
    14 replies | 331 view(s)
  • John Turney's Avatar
    Today, 04:04 PM
    I have a Denis Welch aluminum head and torqued the head nuts per Bentley. The only things I worry about are the spark plugs. Be sure to lube or...
    3 replies | 87 view(s)
  • Madflyer's Avatar
    Today, 03:13 PM
    Madflyer replied to a thread Alloy cylinder head in Austin Healey
    I do not think there would be a problem with OEM torque that being said did it come with a head gasket and new head bolts. There is a rotation to...
    3 replies | 87 view(s)
  • Madflyer's Avatar
    Today, 02:51 PM
    Madflyer replied to a thread TR2/3/3A What does a condenser do? in Triumph
    I do not know much about Yellow wires or blue wires bad or good. With aircraft we can not pull over, quality is foremost. Mexico China US UK follow...
    20 replies | 338 view(s)
  • 2liter4cyl's Avatar
    Today, 02:33 PM
    2liter4cyl replied to a thread TR2/3/3A What does a condenser do? in Triumph
    There are 2 numbers to consider with capacitors: capacitance, measured Farads, in this case micro-micro farads (MMF) like .2-.25 MMF or maybe...
    20 replies | 338 view(s)
  • Madflyer's Avatar
    Today, 02:01 PM
    Madflyer replied to a thread TR2/3/3A TR3 Headlamp Rings in Triumph
    Been there done that. OK first some questions. Did you get the ones with the screw hole on the bottom? If no hole you have latter year rings that fit...
    1 replies | 33 view(s)
  • Basil's Avatar
    Today, 01:59 PM
    Basil replied to a thread New Member in New Member Introductions
    Welcome aboard David! I used to live just across the river from you in Troy, IL (back in the early 90's when I was stationed at Scott AFB).
    1 replies | 17 view(s)
  • Exotexs's Avatar
    Today, 01:59 PM
    Banjo Steering wheel with center emblem and shaft nut, Owner's Handbook, Service Record booklet. Selling as a group, will not separate. Make...
    0 replies | 8 view(s)
  • Sarastro's Avatar
    Today, 01:57 PM
    Sarastro replied to a thread TR2/3/3A What does a condenser do? in Triumph
    First, yes, they really do fail. The foil package itself is not the problem; it's the sloppily made connections to it. Some time ago, in order to...
    20 replies | 338 view(s)
  • Madflyer's Avatar
    Today, 01:35 PM
    Madflyer replied to a thread Engine Stutter in Austin Healey
    We do take rides to LT and have club members at the Keys and at the lake side of Kingsbury grade. Since C 19 we have only gone ounce and did not...
    15 replies | 272 view(s)
  • DPStL's Avatar
    Today, 12:52 PM
    DPStL started a thread TR2/3/3A TR3 Headlamp Rings in Triumph
    I am sure the TR3 Headlamp Ring fittings made sense to some engineer at one point but I am completely dumbfounded and frustrated. There are several...
    1 replies | 33 view(s)
  • RJS's Avatar
    Today, 12:49 PM
    RJS replied to a thread TR4/4A General exhaust questions in Triumph
    Hi Hope I am not too late to the party. My '66 TR4A originally came with the twin exhausts. During restoration, the PO installed the single TR4A...
    17 replies | 430 view(s)
  • DPStL's Avatar
    Today, 12:47 PM
    Hello All; New member and learning a lot about Triumphs. We always had Healeys and a Jag at one point growing up but I always loved Triumphs. ...
    1 replies | 17 view(s)
  • Lin's Avatar
    Today, 12:24 PM
    Lin replied to a thread "A" Pillars: A Question in Austin Healey
    Hah. Shortly after that photo was taken I purchased a lift. One of the best decisions I ever made! Lin
    7 replies | 235 view(s)
  • Grantura_MKI's Avatar
    Today, 12:21 PM
    I only use single stage paints. Getting more difficult to come by here in Cali. i use PPG paints with the clear already mixed in. Is sold under the...
    7 replies | 67 view(s)
  • Jerry's Avatar
    Today, 10:56 AM
    I have painted with both types. My last full car, I painted with single stage and let it dry. Then sanded it and followed it with a clear coat. ...
    7 replies | 67 view(s)
  • Jerry's Avatar
    Today, 10:49 AM
    I don't know the answer on the pillars but I think Lin needs a lift so he does not have to work on the ground! Best investment I ever made!
    7 replies | 235 view(s)
  • Randy Forbes's Avatar
    Today, 09:56 AM
    I had always thought it was due to the wrap around windscreen* so I guess you could say rollup windows and not be wrong ;) *So that raises the...
    7 replies | 235 view(s)
  • Patrick67BJ8's Avatar
    Today, 08:40 AM
    I would contact Rawles for the info you want.
    3 replies | 87 view(s)
  • HealeyRick's Avatar
    Today, 06:07 AM
    If you squint your eyes, that really seems to work. Now, if I can just find a 911 cheap. In terms of using another car roof to create a fastback,...
    29 replies | 916 view(s)
  • mgtf328's Avatar
    Today, 04:05 AM
    My BJ8 has a Rawles motorsport alloy head and puts puffs of blue smoke out when it starts from cold, valve seals I expect. I've been stoking...
    3 replies | 87 view(s)
More Activity