LionelJrudd
Jedi Trainee
Offline
When I remade the firewalls for my car I bent the bottom flange forward as I have seen in a photograph in Roger William's book How to Restore Triumph TRs. There was no material left on the originals to use as a guide.
Logic suggests that it would fold to the rear and hence support the front of the floor panels. The replacement panels from Kilmartion Automtive Sheetmetal in Ballarat, Victoria, have enough length to reach through under the flange as I have bent it. Does it do this and is simply spot welded to the firewall flange?
I also think I read in one of the forums that it went to the rear but can't remember where. (Potentially my memory at fault)
Can anyone give me correct guidance on this?
Logic suggests that it would fold to the rear and hence support the front of the floor panels. The replacement panels from Kilmartion Automtive Sheetmetal in Ballarat, Victoria, have enough length to reach through under the flange as I have bent it. Does it do this and is simply spot welded to the firewall flange?
I also think I read in one of the forums that it went to the rear but can't remember where. (Potentially my memory at fault)
Can anyone give me correct guidance on this?