I hope someone can help. I am restoring a BN1. I am at the point of replacing the two rear chassis to shroud extentions.
The last owner removed the old ones so I have no way of setting the new ones at the right high so the body will fit right.
Can anyone tell me the right height of he extentions.
I was going to place a straight edge along the top chassis then measure up to the centre of the top bumper bracket hole.
Hope this makes sense.
Thanks for any help
Regards Norman
The last owner removed the old ones so I have no way of setting the new ones at the right high so the body will fit right.
Can anyone tell me the right height of he extentions.
I was going to place a straight edge along the top chassis then measure up to the centre of the top bumper bracket hole.
Hope this makes sense.
Thanks for any help
Regards Norman
Last edited by a moderator: