D
Deleted member 21878
Guest
Guest
Offline
while waiting for parts i thought i would start a check list on installing the timing chain.
i was reading thru the manual and it talked about using the same number of shims as came out from behind the crank to be sure the gars are aligned. two questions here
1) my engine did not have any shims behind the crank gear. so i thought i might go ahead and check to see everything is in line. To do that do i have to put on both gears and then take them back off when ready to install? or can i measure somehow? i would assume this must be done with the chain off.
2) my parts list and the manual do not mention any shims behind the cam gear. are there any on the cam and if not, how do you adjust run out?
Thanks
i was reading thru the manual and it talked about using the same number of shims as came out from behind the crank to be sure the gars are aligned. two questions here
1) my engine did not have any shims behind the crank gear. so i thought i might go ahead and check to see everything is in line. To do that do i have to put on both gears and then take them back off when ready to install? or can i measure somehow? i would assume this must be done with the chain off.
2) my parts list and the manual do not mention any shims behind the cam gear. are there any on the cam and if not, how do you adjust run out?
Thanks