D
Deleted member 21878
Guest
Guest
Offline
i have been reading posts and articles on the conversion. i want to use my voltage regulator so i wired today as i have seen in these articles. just wanted to make sure this looked right to you all. basically A1 terminal has the blue/brown wire; A terminal has the yellow wire from the alt and the two brown wires; the F terminal has no wires; the D terminal has the yellow green wire from the alt and the smaller yellow wire from the dash light; the E terminal has the black ground wire.
see pic
few questions:
do i need to run any other wires for the conversion? obviously i need to connect the ones to the alternator when i finally get one. i thought i read somewhere about getting a three wire alternator so wondered where the other wire went. not sure i saw anything about that.
this is a new wiring harness. are the wires in the harness heavy enough?
last, i read a lot about the wiring but not really how to place the pieces in the contacts so they can not connect. i used wire shrink to isolate the connections. i slipped one over the verticle bar on the right, isolating the front and the back of it. then i slipped another piece behind the contacts next to the coils. is this enough? anything else i need to do?
No engine in yet so i can do most anything necc without much fanfare.
Thanks
see pic
few questions:
do i need to run any other wires for the conversion? obviously i need to connect the ones to the alternator when i finally get one. i thought i read somewhere about getting a three wire alternator so wondered where the other wire went. not sure i saw anything about that.
this is a new wiring harness. are the wires in the harness heavy enough?
last, i read a lot about the wiring but not really how to place the pieces in the contacts so they can not connect. i used wire shrink to isolate the connections. i slipped one over the verticle bar on the right, isolating the front and the back of it. then i slipped another piece behind the contacts next to the coils. is this enough? anything else i need to do?
No engine in yet so i can do most anything necc without much fanfare.
Thanks