Well the weather is cooling down in my shop to 65 and I started back on the bodywok after using the heat of summer to bend vinyl for the seats and interior. I have been priming and filling and priming the doors and fenders and I have a question about were the bottom and side meet on the doors. They come together like the ridge of a roof on a house and create a miter line.
Plus the door handle area is low around the handle and I see that on a lot of restored tr3s. Can I leave these areas and the eye will accept them as normal or does the door have to have a flat plane and the handle perfectly level. My pictures are the not the best, but I hope I got the basic difficulty and question.
steve
Plus the door handle area is low around the handle and I see that on a lot of restored tr3s. Can I leave these areas and the eye will accept them as normal or does the door have to have a flat plane and the handle perfectly level. My pictures are the not the best, but I hope I got the basic difficulty and question.
steve