Online
There has been a slow, gradual decline in my engine's oil pressure for a while now--60 to 65 psi on start-up from cold dropping at running temperatures to 30-35 psi at 3K rpm's and 10 psi or less at fast idle. Yesterday I took the car for a long ride and after a while at 65-70 mph the oil pressure actually dropped below 30 psi, so it's now officially below the "10 psi/1K rpm's" threshold.
The engine has about 60K on it since complete rebuild so this morning I decided to bite the bullet and drop the sump with the hope that I will find nothing worse than a worn oil pump and/or main or rod bearings, either of which I can repair/replace in time for some fall driving.
I first removed the spin-on oil filter and upon cutting it apart noticed a bit of black plastic debris--irregularly shaped pieces, almost gravel-like perhaps 1/16" to 1/8" in dimension on one end of the cartridge. The filter medium itself was fairly clean though I did notice a bit more shiny bearing-like material than I would have liked to have seen.
While draining the pan I heard a clunk or two from some solids going through the drain hole and landing in a catch pan and on examination I found a couple of larger pieces of the same kind of stuff--definitely some black plastic material, not particularly hard as it would give when bitten.
The big surprise was what I found when I removed the pan--a lot more of the same small stuff and four segments of a black plastic piece. In the attached thumbnail you'll see that they form a semi-circle about 5" in diameter and notice on the two pieces in the 9 o'clock position that there appears to have been some gear-like teeth molded in. The small debris is inside the semi-circle.
I'm going to remove the oil pump tomorrow but wonder if anyone has an idea as to what this stuff could be?
The engine has about 60K on it since complete rebuild so this morning I decided to bite the bullet and drop the sump with the hope that I will find nothing worse than a worn oil pump and/or main or rod bearings, either of which I can repair/replace in time for some fall driving.
I first removed the spin-on oil filter and upon cutting it apart noticed a bit of black plastic debris--irregularly shaped pieces, almost gravel-like perhaps 1/16" to 1/8" in dimension on one end of the cartridge. The filter medium itself was fairly clean though I did notice a bit more shiny bearing-like material than I would have liked to have seen.
While draining the pan I heard a clunk or two from some solids going through the drain hole and landing in a catch pan and on examination I found a couple of larger pieces of the same kind of stuff--definitely some black plastic material, not particularly hard as it would give when bitten.
The big surprise was what I found when I removed the pan--a lot more of the same small stuff and four segments of a black plastic piece. In the attached thumbnail you'll see that they form a semi-circle about 5" in diameter and notice on the two pieces in the 9 o'clock position that there appears to have been some gear-like teeth molded in. The small debris is inside the semi-circle.
I'm going to remove the oil pump tomorrow but wonder if anyone has an idea as to what this stuff could be?