Hi,
I'm going to pull the transmission on my TR6 to get at the clutch. The clutch is very stiff, but I will start another thread on that once I found out what I've got in there.
The body is off, so I have easy access and lots of room. I have read up on the process in the shop manual but there isn't much info in it. I will fabricate a support for the back end of the engine.
Is there anything I should know about the process, such as locating dowels etc. to keep an eye out for?
Thanks
Todd.
I'm going to pull the transmission on my TR6 to get at the clutch. The clutch is very stiff, but I will start another thread on that once I found out what I've got in there.
The body is off, so I have easy access and lots of room. I have read up on the process in the shop manual but there isn't much info in it. I will fabricate a support for the back end of the engine.
Is there anything I should know about the process, such as locating dowels etc. to keep an eye out for?
Thanks
Todd.