Offline
I'd like to put TR6 door seals on my TR4A, which I understand is a common thing to do. These are one-piece seals which fit over the flange between the rocker and inner sill, and I'm told they can replace the two-piece factory seal. I like the idea of doing this, as the channel for the outer seal in my TR4A is badly rusted, and this will allow me to remove it completely.
I'm puzzled about how the TR6 seals fit at the triangular gusset in the lower rear corner of the door. It seems to me that the rubber part of the seal will seal against the door panel, which really isn't what you want (picture below). Or, is there some way to get around this, short of removing the gusset?
I'm puzzled about how the TR6 seals fit at the triangular gusset in the lower rear corner of the door. It seems to me that the rubber part of the seal will seal against the door panel, which really isn't what you want (picture below). Or, is there some way to get around this, short of removing the gusset?