ties581006
Freshman Member
Offline
The BN4 is progressing slowly--now into welding new outriggers and sills. As I am taking such efforts to remove, transform and/or encapsulate visible rust I'm thinking about inside of the main frame. I'm not planning to send the chassis out for dipping, so looking for DIY solutions. The main frame has surface rust wherever the original rust proofing was not liberally applied (oil leaking) but no rust through.
What have you done, if anything, for the inside of the frame? If coated, what with? How did you apply it? Did you end up drilling extra holes in the frame? Should I just leave it alone and hope for the best?
Any ideas for what to do or not to do would be greatly appreciated.
Mike T in Minnesota.
What have you done, if anything, for the inside of the frame? If coated, what with? How did you apply it? Did you end up drilling extra holes in the frame? Should I just leave it alone and hope for the best?
Any ideas for what to do or not to do would be greatly appreciated.
Mike T in Minnesota.