I have just about rebuilt this engine, but I have to remove the keys from the Crankshaft in order to put in new shims. I have no idea how to do it, but they do not tap out easily ( or at all ) with a chisel.
(The timing sprockets were out of alignment by 15 thou and the old timing chain tensioner and pin were destroyed, so it really does seem a good idea to line them up better.)
I have sprayed with Liquid Wrench and left to it soak, but this is quite a challenge Any and all suggestions will be welcome!
(The timing sprockets were out of alignment by 15 thou and the old timing chain tensioner and pin were destroyed, so it really does seem a good idea to line them up better.)
I have sprayed with Liquid Wrench and left to it soak, but this is quite a challenge Any and all suggestions will be welcome!