Search:

Type: Posts; User: Mike Tobin; Keyword(s):

Search: Search took 0.00 seconds.

  1. Re: What's with all the Engine Rebuild Failures?

    I'll let y'all know when I finally get it started. Now that the weather's warmed up and the frustration level is back down it's safe to start working again. Back to the timing chain so pulling the...
  2. Re: trouble on 1st start

    "Also, there have been a lot of discussions in the past about certain electronic ignition modules failing if the 12VDC power is left on them for too long without starting and running the engine."...
  3. Re: trouble on 1st start

    No one's mentioned vacuum. Need that too. I'm tracing that on my rebuild-won't-start. Spark and compression everywhere. Timing on the mark. Vacuum at each manifold (minus the carb) but not with...
  4. Replies
    7
    Views
    618

    Re: Mating OD to gearbox

    Make sure the cam is on right-side up!

    Don't ask why I know this is important.
  5. Replies
    8
    Views
    662

    Re: Austin Healey Experience Site

    Website Emergency MaintenanceDue to an unexpected hardware failure, this website is not currently available.
    No data has been lost, I'm working around the clock to restore service, but it may be...
  6. Replies
    5
    Views
    632

    Re: Healey Doors

    Had the problem with my BT7. I finally figure out the the scuttle had moved in relation to the sills - it had dropped a bit and tilted back. I cut the welds at the sill/scuttle joint and with a...
  7. Re: Should I remove driver's side fender to work on footbox on my BN1?

    I found that the flange at the rear of the fender would not clear the space between the hinge post and the door. The door had to come off. Hint putting it back on. cut the heads of a couple bolts...
  8. Replies
    6
    Views
    547

    Re: Ignition light lense

    I made new ones.
    Used binder divider tabs - the ones with the clear plastic. Each tab is a different color.
    In my drift set there was one the same size as the lens whole. I punched it out of the...
  9. Replies
    15
    Views
    1,200

    Re: new wiring harness

    I got mine from British Wiring. It was just about perfect.
  10. Replies
    15
    Views
    1,200

    Re: new wiring harness

    I put a 7-gang box in mine with the new harness. Fits in the original mounting holes.
    Charlie Hart hartcg@msn.com.
    50441
  11. Replies
    14
    Views
    2,282

    Re: Conversion to alternator

    Put the Moss kit in today. Painted Healey puke green it looks right at home. Easy fit.
  12. Replies
    6
    Views
    4,455

    Re: What's a "Restoration?"

    Started closer to Concours than Driver Frame-Off. Then I discovered McMaster Carr. Screw cleaning the original screws! I'm now firmly in the "If it's broke buy a new one!" SS ignition,...
Results 1 to 12 of 12