• Recent Articles

  • Recent Forum Posts


    Re: Ideas needed for under dash radio mount, cup holders, glove box

    Work in progress... gauge panel for new EFI build. The ECU is behind the upper portion of the gauge panel. Much to do... gauge panel removes with 2

    HealeyPassion Today, 12:01 AM Go to last post

    Re: Triumph GT6, basic work estimates

    Umm... ...itís Dallas. Pretty sure thatís a factory feature on most vehicles, especially 21st century models.

    UmmYeahOk Yesterday, 11:59 PM Go to last post
    Drone Dog

    Re: Tri-carb PCV valve

    you are only now wondering???? ha, you should talk to my wife.

    yes, my primary objective was to help stop oil leaks or potential

    Drone Dog Yesterday, 10:14 PM Go to last post

    Re: Intro message from wclyde

    Welcome aboard - should like you have some fun ahead of you with your "sorting out". You will find plenty of help here in our Triumph forum!

    Basil Yesterday, 09:38 PM Go to last post

    Intro message from wclyde

    I am the brother mention in this previous post by papajim. He said it very well, so I am reusing: "My younger brother recently purchased a 1974

    wclyde Yesterday, 09:31 PM Go to last post
  • Recent Blog Posts


    Connections for a 'Service Warning Module' - 1976 MG-B

    I am rebuilding a 1976 MG-B that I purchased non-running. There are a few 'modifications' to the electrical system, particularly in the motor compartment.

    I found a module that is mounted on a...

    Spit451 02-04-2019 12:04 PM
  • Twitter