• Recent Articles

  • Recent Forum Posts

    LionelJrudd

    Re: Moving a radius on sheet metal patch

    I'm with the "define the new line with hammer and dolly and work the existing line back into the curve" camp. Had to do this with one of the

    LionelJrudd Today, 08:36 PM Go to last post
    tinman58

    Re: Front carb spitting fuel out overflow

    Taken apart the needle valve replaced with the old one that worked. He did say there was a little bit of crud on the first go round. He did swap out the

    tinman58 Today, 08:33 PM Go to last post
    Graham H

    Re: Block Water Outlet Valve

    I changed the tap for a modern ball type valve which I can fit a 1/4 inch hose on the end to direct the coolant away from the block and chassis. Because

    Graham H Today, 08:33 PM Go to last post
    BJ8Healeys

    Re: 66 BJ 8 Positive ground identification

    Jeff, you have described a positive ground car. You can change to negative ground by turning the battery 180 degrees and reconnecting the battery cables.

    BJ8Healeys Today, 08:32 PM Go to last post
    sp53

    gauge sending unit

    On the gas gauge sending unit there are 2 studs, one larger than the other. Is the larger one the case ground? It is the most inside one.

    sp53 Today, 08:30 PM Go to last post
  • Recent Blog Posts

  • Twitter