• Tools

    There is no available content in category Tools
  • Recent Articles

  • Recent Forum Posts

    Tybalt

    Re: Scuttle lid spring?

    It's a bit of an awkward shot but here you go. The spring is oriented forward into two spot welded clips on the bulkhead that are roughly above the two

    Tybalt Today, 11:15 AM Go to last post
    Tr4aJim

    Re: Replacing rear pinion seal - remove driveshaft?

    I tried using a hooked seal puller, but with the pinion shaft in the way, I couldn’t get good leverage against the seal. I just chewed up the inner

    Tr4aJim Today, 11:14 AM Go to last post
    Keith_M

    Re: engine hoist

    Hi TL,
    Here are a few picture from my installation.
    Keith


    Keith_M Today, 10:57 AM Go to last post
    TRMark

    Re: Hydraulic lift opinions/info needed

    I paid $1995 delivered for my cheap 8000 lb 4 post lift. Cable were not routed properly so I had to fix that, not big problem. I will probably never

    TRMark Today, 10:56 AM Go to last post
    Zitch

    Re: Hydraulic lift opinions/info needed

    I have a 9000# 2 post because I didn't need the storage space and I had the ceiling height. Cost about $2600 installed in Southern Missouri.

    Zitch Today, 10:16 AM Go to last post
  • Recent Blog Posts

    RichardOlyn

    67 Healey 3000 MKIII BJ8

    I recently acquired a frame off restoration of a 67 Austin Healey BJ8 and the water temp gauge does not move. I had the gauge replaced once already and determined that the old gauge was not working...

    RichardOlyn 01-05-2018 12:26 PM
  • Twitter