• Restoration/Car Care

    There is no available content in category Restoration/Car Care
  • Recent Articles

  • Recent Forum Posts

    TR3driver

    Re: Rear end questions

    Yeah, should be OK even with shims.

    Only a slim chance it will be anything other than 3.70 ratio. The housing and carrier remain the same,

    TR3driver Today, 09:14 PM Go to last post
    vixen-mk2

    Re: Lotus Elan S4..Bodywork evaluation..Strip & Paint?

    If you have no experience on glass fiber like myself i would grab any help Grantura offers you with both hands i have seen his work and its second to

    vixen-mk2 Today, 09:05 PM Go to last post
    AngliaGT

    Re: My Lucky Day

    You're lucky - I can't even get anyone to stop by & visit.
    Been here almost 1-1/2 years,& even joined the local British car club,but no

    AngliaGT Today, 08:40 PM Go to last post
    trrdster2000

    Re: Boot lid thread plates loose in stiffener

    When you tighten down the hinges they will stop moving. Just get them sung enough to move so you can line up the seams around the lid.
    Don't get

    trrdster2000 Today, 08:35 PM Go to last post
    blokey

    Boot lid thread plates loose in stiffener

    I am refinishing the boot lid on my TR6 and noticed that the threaded plate for attaching the boot lid to the hinge is loose and rattling around inside

    blokey Today, 07:53 PM Go to last post
  • Recent Blog Posts

    Spit451

    Connections for a 'Service Warning Module' - 1976 MG-B

    I am rebuilding a 1976 MG-B that I purchased non-running. There are a few 'modifications' to the electrical system, particularly in the motor compartment.

    I found a module that is mounted on a...

    Spit451 02-04-2019 12:04 PM
  • Twitter