• Restoration/Car Care

    There is no available content in category Restoration/Car Care
  • Recent Articles

  • Recent Forum Posts


    Re: Question on overdrive pinion & bearing assembly for speedo drive

    Thanks Randall! I didn't realize that the bearing came apart. Now I see the faint line where it must separate. I measured the flat sides and I get 15.79mm

    TuffTR250 Today, 04:21 PM Go to last post

    Re: Mg Midget # 4

    BTW JPSmit the Viva was the first car I ever owned in England in the 70's first engine I ever rebuilt too lol.

    SWC Today, 04:13 PM Go to last post

    Re: slim pickings

    You should find this helpful:

    HealeyRick Today, 04:10 PM Go to last post

    Re: Mg Midget # 4

    Thanks for the welcome everyone.

    SWC Today, 04:10 PM Go to last post
    Mickey Richaud

    Re: slim pickings

    MGB hubs are designed to be torqued to a specific value. Not like many other cars where you tighten the hub until it "feels right". The design

    Mickey Richaud Today, 04:00 PM Go to last post
  • Recent Blog Posts

    Alistair Menzies

    Electrical woes 1976 TR6

    Ignition switch failed or so I thought! Sourced new 6 terminal type from U.K..
    On fitting I notice that one of the terminals in the female connection, way up under dash, has nothing in it.
    Is this...

    Alistair Menzies 05-21-2018 04:55 PM

    Tr7 carborator switch out

    Hello all, I am looking at changing my 1980 TR7 to the weber carborator. Has any one done this or know of any reference material I could look over before I start. Thanks in advance for any help.

    Zildjian 05-14-2018 08:40 PM
  • Twitter