• Motorcycles

    There is no available content in category Motorcycles
  • Recent Articles

  • Recent Forum Posts

    Patrick67BJ8

    Re: Break In procedure

    I primed my engine first with Joe Gibbs "breakin oil". My club has a Engine Stand and a DYI oil primer tool we use to prime the engine with

    Patrick67BJ8 Today, 12:40 PM Go to last post
    Bob_Spidell

    Re: Running out of gas

    Maybe I'm too picky, but I want all my gauges to be at least nominally functioning (I spent years and dollars getting a reasonably good speedometer indication).

    Bob_Spidell Today, 12:38 PM Go to last post
    77MidgetMkIV

    Back at it!

    Hello all!

    So, after an extended almost 10 year hiatus that included a divorce, 3 house moves, 3 job changes, getting remarried, and all

    77MidgetMkIV Today, 12:35 PM Go to last post
    Zitch

    Re: A simple solution for separating axle and hub.

    you should add this to the maintenance articles. Very nice!

    Zitch Today, 12:34 PM Go to last post
    TFB

    Re: Engine Teardown on the Way

    I had to take the pan off my fresh motor the Po had rebuilt for a loud knock that was rod lock tab hitting the oil pan baffle.I plasti guaged some rods

    TFB Today, 12:28 PM Go to last post
  • Recent Blog Posts

    JimLaney

    Making piles of piles

    Had a day to spend on the sprites. Worked on identifying system components and parts of sub-assemblies. Began with water circulation system and listing all the parts that needed to be replaced....

    JimLaney 01-01-2017 10:55 AM
  • Twitter