• Sunbeam

    There is no available content in category Sunbeam
  • Recent Articles

  • Recent Forum Posts

    FlyingCat

    Re: What hoses go where...

    You're exactly right! I found the thingy on the distributor where the hose goes, and then connected it to the carburetor. Smooth as Marvel Mystery Oil.

    FlyingCat Today, 06:43 PM Go to last post
    Keoke

    Re: Battery Fuse Protection

    HI Bob:

    The slow blow fuse was specifically designed to handle Inductive circuits , most of which contain a motor.
    They address the

    Keoke Today, 06:35 PM Go to last post
    Happy Horse

    Re: Looks like a great resource site

    Thanks for the reply. Malmstrom is still there and thriving. Hopefully, your time in Montana was enjoyable! I was born and raised in Billings back

    Happy Horse Today, 06:20 PM Go to last post
    zabond

    Re: Peanut Butter?

    Look's a bit flaky to be condensation to me, soak a bit up on paper towel, if it spreads all over its condensation, if it stays solidified its grease

    zabond Today, 05:51 PM Go to last post
    RAC68

    Re: Tri-carb PCV valve

    Drone-Dog,

    I can see where the crankcase breather you installed would perform whether restricted or not. Lets assume that you are starting

    RAC68 Today, 03:54 PM Go to last post
  • Recent Blog Posts

    Spit451

    Connections for a 'Service Warning Module' - 1976 MG-B

    I am rebuilding a 1976 MG-B that I purchased non-running. There are a few 'modifications' to the electrical system, particularly in the motor compartment.

    I found a module that is mounted on a...

    Spit451 02-04-2019 12:04 PM
  • Twitter