• Recent Articles

  • Recent Forum Posts

    Michael Oritt

    Re: Need suggestions for fastening aftermarket hardtop for BN1.

    Here's a pic of the bracket and swingbolt supplied by NICAL for my hardtop. I am quite sure they can be purchased separately from a hardtop.

    Michael Oritt Today, 10:40 PM Go to last post
    Healey Nut

    Re: Paint job

    My painter used a single stage gloss finish paint for the superstructure as it has more solids in it so goes on a bit thicker without runs and also saves

    Healey Nut Today, 10:07 PM Go to last post
    TR3driver

    Re: Trim Hole Size

    FWIW, on the LAD I use the bottom plate as a template to make the 4 slits for the prongs, then install the fastener and use an X-acto knife to cut the

    TR3driver Today, 09:34 PM Go to last post
    TR3driver

    Re: Speedometer is off by 10 mph??

    Hmm, I wonder if there would be a market for a similar device, that could be calibrated to compensate for non-linearities in the speedo head? It would

    TR3driver Today, 09:31 PM Go to last post
    SebringGlenn

    Re: New 5 speed conversion for 280i guys

    This is great info... I have a non running 280i and no trans at all... yes i responded to a 10 year old thread.
    Glenn

    SebringGlenn Today, 09:31 PM Go to last post
  • Recent Blog Posts

  • Twitter