• Recent Articles

  • Recent Forum Posts

    Adam at ATB

    Re: BJ8 Measurement

    Yes frame is done just trying to work out the position of the radius arm box on the heel board , i know the correct height , just need a measurement from

    Adam at ATB Today, 05:29 PM Go to last post
    Keoke

    Re: BJ8 Measurement

    Not clear, is the frame complete end to end?

    Keoke Today, 04:59 PM Go to last post
    Adam at ATB

    BJ8 Measurement

    Can anyone help me? Iím restoring a phase 2 BJ8 and the rear end was totally rusted away.

    The measurement I need is from the side of the

    Adam at ATB Today, 04:48 PM Go to last post
    TR3driver

    Re: Exhaust Header Fitment

    If it were me, I'd replace it with a new one. Those old lines can sometimes get brittle with age, and it only takes a tiny crack on the inside to cause

    TR3driver Today, 04:47 PM Go to last post
    Alfred567

    Camshaft

    Can anyone identify a Cam with number J9097 on the end?

    Thank You

    Alfred567 Today, 04:43 PM Go to last post
  • Recent Blog Posts

  • Twitter