• Bayless

    There is no available content written by Bayless
  • Recent Articles

  • Recent Forum Posts


    Re: Leaking ft hub seals

    I may have too much grease installed into the hub. I am using the reinforced spindle kit with the shims and spacer installed so there is less room for

    HAWAIICJ Today, 12:27 PM Go to last post
    Westcoast M5

    Re: The Journey Begins - BJ8 restoration

    Okay, time for a few photos. I have begun building the superstructure. So nice to be past the greasy / rusty work and on to this phase. Now it feels

    Westcoast M5 Today, 12:10 PM Go to last post

    Re: Clunking noise in rear continuing

    Update. Making one last try to get the wheel off myself, I planned to heat the spinner with a propane torch, wire up the wrench so it wouldn't fly off

    pdplot Today, 12:09 PM Go to last post

    Re: Oil leak from rear of motor.

    Yes the one that is like half a circle at the bottom of the bell housing.

    mallard Today, 10:30 AM Go to last post

    Re: Leaking ft hub seals

    IMO you are using too much grease. The felt is only supposed to be a dust seal, it doesn't hold back grease (and shouldn't need to). The other possibility

    TR3driver Today, 10:09 AM Go to last post
  • Recent Blog Posts

  • Twitter