• pan

    There is no available content written by pan
  • Recent Articles

  • Recent Forum Posts

    red57

    Re: Lilly Engine update / couple of questions

    Drone Dog.

    I really hope I am reading this wrong, but if you are saying the nut was bottomed out on the crank shoulder and not gripping the

    red57 Today, 09:50 PM Go to last post
    ckdove

    Re: 72 TR6 Commision Plate and location?

    Thanks Andrew, I do have the tag on the windshield post and it matches. From what I can tell the commision plate changed over to the later version somewhere

    ckdove Today, 09:47 PM Go to last post
    glemon

    Re: Replacing rear pinion seal - remove driveshaft?

    I did it on my 4a many many years ago. Pretty sure it was a disconnect and slide the driveshaft back and out of the way operation. Don't remember the

    glemon Today, 09:40 PM Go to last post
    steveg

    Re: Lilly Engine update / couple of questions

    Two things to check:
    --make sure the spin-on filter adapter is on correctly. Mine had a "T" for Top stamped on the top of the curvature.

    steveg Today, 09:29 PM Go to last post
    JimLaney

    How to treat media blasted steel

    Cleaned my engine back plate with media blaster to remove surface rust. I want to mount it on the assembled block and paint it but I don't want flash

    JimLaney Today, 09:23 PM Go to last post
  • Recent Blog Posts

    RichardOlyn

    67 Healey 3000 MKIII BJ8

    I recently acquired a frame off restoration of a 67 Austin Healey BJ8 and the water temp gauge does not move. I had the gauge replaced once already and determined that the old gauge was not working...

    RichardOlyn 01-05-2018 12:26 PM
  • Twitter