• mrunci

    There is no available content written by mrunci
  • Recent Articles

  • Recent Forum Posts

    Drone Dog

    Re: Water Pump Failure - Diagnostic Steps?

    usually if a water pump is going bad to the point of making a noise, you can wiggle the fan.

    Drone Dog Today, 09:48 PM Go to last post
    Healey Nut

    Re: engine hoist

    I used that plate to lift the whole driveline . The angle was too steep but using a combination of my hoist and a cumalong up to a 2X8 across the runways

    Healey Nut Today, 09:27 PM Go to last post
    Drone Dog

    Re: engine hoist

    healey nut... interesting way to do it. seems like less stress on the studs that way.

    i have a leveler. just was not sure where to run the

    Drone Dog Today, 09:20 PM Go to last post
    Popeye

    Re: Rodney Dangerfield's Guide to Auto Repair

    Awesome!

    Popeye Today, 09:19 PM Go to last post
    Drone Dog

    Re: Lilly Engine update / couple of questions

    and another pic of the same thing

    the larger diameter pipe goes in the #4 main bearing. on my car it was not straight up. it leaned toward

    Drone Dog Today, 09:07 PM Go to last post
  • Recent Blog Posts

    RichardOlyn

    67 Healey 3000 MKIII BJ8

    I recently acquired a frame off restoration of a 67 Austin Healey BJ8 and the water temp gauge does not move. I had the gauge replaced once already and determined that the old gauge was not working...

    RichardOlyn 01-05-2018 12:26 PM
  • Twitter