• Recent Articles

  • Recent Forum Posts

    Drone Dog

    Re: Tri-carb PCV valve

    i have been looking at the air inlet issue and have modified my plumbing to what i think gives me an air intake without changing the looks... too much.

    Drone Dog Today, 08:50 AM Go to last post

    Re: Battery Fuse Protection

    Hi John,

    You make a very good point. I can see where separating lines for run-rate car operations from engine starter operations could potentially

    RAC68 Today, 08:46 AM Go to last post

    Re: Tri-carb PCV valve

    Hi All,

    Maybe I have missed something. but I would expect a filtered air port in a newer engine’s PCV system would be there to allow

    RAC68 Today, 08:26 AM Go to last post
    Mickey Richaud

    Re: Triumph GT6, basic work estimates

    ~Donning my moderator hat~ First, like the others who've posted, I'm sorry you've had such a negative experience. It does sour the joy we all want from

    Mickey Richaud Today, 07:16 AM Go to last post
    Graham H

    Re: Looking for the Voice of Experience

    If there is any lead left in that top piece it will melt when you weld that corner or rear bracket on, I just used soft solder to build it up again.

    Graham H Today, 05:07 AM Go to last post
  • Recent Blog Posts


    Connections for a 'Service Warning Module' - 1976 MG-B

    I am rebuilding a 1976 MG-B that I purchased non-running. There are a few 'modifications' to the electrical system, particularly in the motor compartment.

    I found a module that is mounted on a...

    Spit451 02-04-2019 12:04 PM
  • Twitter