• Recent Articles

  • Recent Forum Posts

    Bob McElwee

    Re: Brits in the Ozarks

    Congrats, Paul.

    Bob McElwee Today, 03:41 PM Go to last post
    JimLaney

    Re: Refurbishing the trunk lid

    Thanks Rut. I have some experience welding but this thin material made me think twice about cutting out the bracing. I'll take your advice and clean it

    JimLaney Today, 03:38 PM Go to last post
    John Kuzman

    Re: 5 Speed Driveshaft Yoke

    UPDATE: I am officially 5 speeding! The Gearbox Guru from the race shop stopped by my shop last Saturday (Okay, I enticed him with a six-pack). He looked

    John Kuzman Today, 03:18 PM Go to last post
    tomshobby

    Re: Which spark lug to use - copper/platinum/iridium

    I was talked into trying a set of Bosch Platinum plugs in my TR6 before setting out on a 6,000+ mile trip. Before we were half way I switched back to

    tomshobby Today, 03:10 PM Go to last post
    Healey 100

    Re: Clutch Still Slipping after replacing 30W-Non-Det. for Red Line

    Seriously doubt if the tranny oil has anything to do with your clutch slipping. The drains in the bell housing usually do a good job keeping oil from

    Healey 100 Today, 02:07 PM Go to last post
  • Recent Blog Posts

    Alistair Menzies

    Electrical woes 1976 TR6

    Ignition switch failed or so I thought! Sourced new 6 terminal type from U.K..
    On fitting I notice that one of the terminals in the female connection, way up under dash, has nothing in it.
    Is this...

    Alistair Menzies 05-21-2018 04:55 PM
    Zildjian

    Tr7 carborator switch out

    Hello all, I am looking at changing my 1980 TR7 to the weber carborator. Has any one done this or know of any reference material I could look over before I start. Thanks in advance for any help.

    Zildjian 05-14-2018 08:40 PM
  • Twitter