• les m

    Hi Have a 65 TR4A IRS and am going to replace the diff seals and gasket. All are leaking. also while I am there will drop out the swing arms and re bush them as well as replace the wheel bearings and collapsable spacer. I assume its easier to do this on the shed floor rather than in the car. I hope its a case of jacking the chassis up and blocking it then dropping the diff out then same with swing arms. Has anyone done similar or know any problems I might find. any info would be appreciated.
  • Recent Articles

  • Recent Forum Posts

    Andrew Mace

    Re: Clutch Issues

    You may have multiple problems here! First, I would just either rebuild or replace both clutch master and slave cylinders. Once that's done, you might

    Andrew Mace Today, 10:46 AM Go to last post

    Re: Healey Prices

    Bill - strongly agree. Not to mention our small-business suppliers such as Joe Curto, Russ Thompson, Tom Monaco, Jeff Schlemmer and others - all of a

    steveg Today, 10:32 AM Go to last post
    Stan Kowznofski

    Re: 1275 Blueprints

    Thanks Blue Max but I already have that manual. What I am looking for are the actual specification drawings that show all the dimensions, hole &

    Stan Kowznofski Today, 10:28 AM Go to last post

    Re: Today in England

    Last night on Skynews they ran a story about this. It’s nice to see that the crew is being honored.

    Gliderman8 Today, 10:03 AM Go to last post

    Re: Clutch Issues

    Presume the car is not moving when you are shifting gears?
    Could be the MC is frozen up and not returning or something in the clutch is frozen up.

    DavidApp Today, 09:48 AM Go to last post
  • Recent Blog Posts


    Connections for a 'Service Warning Module' - 1976 MG-B

    I am rebuilding a 1976 MG-B that I purchased non-running. There are a few 'modifications' to the electrical system, particularly in the motor compartment.

    I found a module that is mounted on a...

    Spit451 02-04-2019 12:04 PM
  • Twitter