• les m

    Hi Have a 65 TR4A IRS and am going to replace the diff seals and gasket. All are leaking. also while I am there will drop out the swing arms and re bush them as well as replace the wheel bearings and collapsable spacer. I assume its easier to do this on the shed floor rather than in the car. I hope its a case of jacking the chassis up and blocking it then dropping the diff out then same with swing arms. Has anyone done similar or know any problems I might find. any info would be appreciated.
  • Recent Articles

  • Recent Forum Posts

    RAC68

    Re: Ghost in the electrical system

    John,

    Very good analysis and diagnostic procedure.

    Ray(64BJ8P1)

    RAC68 Today, 07:19 PM Go to last post
    sdgorin

    Steve new member

    I am attempting to replace the foam on my 75 TR6 and cannot figure out how to remove the headrests. I am not the most mechanical person but I do have

    sdgorin Today, 07:15 PM Go to last post
    STeve 1958

    Re: Mystery Wood

    I have that too and can't find a use for it. Sometime triumph used wood to create a surface to staple to. Is there a door seal that staples on there.

    STeve 1958 Today, 07:00 PM Go to last post
    Basil

    A better mouse trap?

    Has anyone tried either of these types of traps - the rolling log or the "walk the plank"?



    Or

    Basil Today, 06:49 PM Go to last post
    Basil

    Re: Restoring a 1959 Bugeye from the ground up in Longmont Colorado

    Welcome to the fun! Every time I see Longmint I reminise about the 67 EType coupe I used to have. When I joined the Air Force back in 72 (I lived in

    Basil Today, 06:45 PM Go to last post
  • Recent Blog Posts

    Tom E

    TR3A door lock mechaninsm

    trying to disasemble the door lock and cannot get the smooth circular head bolt off of the door lock slide bar. it is a small bolt that goes thru some sort of lock washer but cannot get it apart
    ...

    Tom E 01-20-2019 02:08 PM
  • Twitter