• A Little Different DGV Installation...

    Just thought I'd share this here in case any other DGV users (or those contemplating using one) might be interested...

    Although I normally run a DCOE I do have a DGV setup I've run for a short time once before. Having a couple of things I want to change on my DCOE setup, I need to install the DGV so I can continue to drive the car while the DCOE is on the workbench.

    I did have a couple of things I wanted to do to the DGV first:
    - I never liked the awkward position of the mixture screw on the side toward the engine
    - The linkage on the carb would not allow the throttle to fully open! This is an issue I've seen on other DGVs as well

    The solution? Mount the carb 180 degrees from the norm....and rework the linkage. Reversing the carb accomplishes a couple of things.
    - Puts the mixture screw on the side next to the wing so it's easy to see and reach
    - Moves the fuel line connection away from the engine and exhaust manifold heat

    The only issue with reversing the carb on this manifold was that I had to open up the top of the manifold a bit since the 36mm choke was now on the opposite side of the manifold and would have been partially shrouded by the manifold. A few minutes with the Dremel solved that.

    I fixed the linkage issue by mounting a bracket to the bottom of the manifold to hold the part of the old linkage that let the cable turn 90 degrees. That also provides a place to attach the return spring. I made sure the new bracket changed the geometry to allow WOT at the cable's maximum pull.

    Just for kicks, I also decided to fashion a heat shield. Don't know if it's really necessary but, when I ran this carb several years ago, I did get some hard starting issues when trying to restart immediately after a long drive....an issue that seemed to be directly related to heat soak after a hot shut down. The heat shield was cut from a piece of 22 gauge steel and the bottom side covered with some self adhesive Thermo Shield material.

    Maybe I can install it this weekend and see how it works. First I have to go to a bicycle shop and get a new throttle cable

    Attachment 41198

    Attachment 41199

    Attachment 41200
    This article was originally published in forum thread: A little different DGV installation... started by Joe Reed View original post
  • Recent Articles

  • Recent Forum Posts


    Re: California Healey Week

    You'd have to ask him. It was built by some well-known racer back then.

    steveg Yesterday, 10:56 PM Go to last post

    Re: 1949 Mercedes

    So, I got the tags. They didn't put the "U.S. Forces in Germany" print on them, or the year. That might actually work to my advantage, as

    SaxMan Yesterday, 10:23 PM Go to last post
    Geo Hahn

    Re: Wiper motor wiring

    Depending on how particular you are -- I think it is more of a brick red than a bright red.

    Geo Hahn Yesterday, 09:51 PM Go to last post

    Re: Dmiles. New member. Tr250 owner

    Hi "D" - glad to have you aboard! Love to see a picture or two!

    Basil Yesterday, 09:25 PM Go to last post

    New member - saying hello

    Lewis Robert here saying hello so the little guy in the middle of my screen will go away. Just purchased a Austin Healey MkIII 3000 BJ8 and am digging

    LewisRobert Yesterday, 09:24 PM Go to last post
  • Twitter