• A Little Different DGV Installation...

    Just thought I'd share this here in case any other DGV users (or those contemplating using one) might be interested...

    Although I normally run a DCOE I do have a DGV setup I've run for a short time once before. Having a couple of things I want to change on my DCOE setup, I need to install the DGV so I can continue to drive the car while the DCOE is on the workbench.

    I did have a couple of things I wanted to do to the DGV first:
    - I never liked the awkward position of the mixture screw on the side toward the engine
    - The linkage on the carb would not allow the throttle to fully open! This is an issue I've seen on other DGVs as well

    The solution? Mount the carb 180 degrees from the norm....and rework the linkage. Reversing the carb accomplishes a couple of things.
    - Puts the mixture screw on the side next to the wing so it's easy to see and reach
    - Moves the fuel line connection away from the engine and exhaust manifold heat

    The only issue with reversing the carb on this manifold was that I had to open up the top of the manifold a bit since the 36mm choke was now on the opposite side of the manifold and would have been partially shrouded by the manifold. A few minutes with the Dremel solved that.

    I fixed the linkage issue by mounting a bracket to the bottom of the manifold to hold the part of the old linkage that let the cable turn 90 degrees. That also provides a place to attach the return spring. I made sure the new bracket changed the geometry to allow WOT at the cable's maximum pull.

    Just for kicks, I also decided to fashion a heat shield. Don't know if it's really necessary but, when I ran this carb several years ago, I did get some hard starting issues when trying to restart immediately after a long drive....an issue that seemed to be directly related to heat soak after a hot shut down. The heat shield was cut from a piece of 22 gauge steel and the bottom side covered with some self adhesive Thermo Shield material.

    Maybe I can install it this weekend and see how it works. First I have to go to a bicycle shop and get a new throttle cable

    Attachment 41198

    Attachment 41199

    Attachment 41200
    This article was originally published in forum thread: A little different DGV installation... started by Joe Reed View original post
  • Recent Articles

  • Recent Forum Posts

    SaxMan

    Re: 1949 Mercedes

    My father told me that the '49 Mercedes was basically a reissue of the '39 Mercedes, as M-B stashed away all the tooling during the war.

    SaxMan Yesterday, 11:45 PM Go to last post
    charleyf

    Re: Front floorpan support

    I agree with Tom, the firewall folds back and under the floor plan on the TR3 before 60000 .

    charleyf Yesterday, 11:42 PM Go to last post
    Michael Oritt

    Re: BJ8 wiring diagram in ladder logic

    Bill--

    Aside from the fact that I would have no other use for the software and it would be $179.00 down the drain I, and probably a number

    Michael Oritt Yesterday, 11:31 PM Go to last post
    steveg

    Re: Standard for the Girling Bubble Flare

    I have two flaring tools: the Ridgid 345 Double flaring tool, which can make doubles or bubbles or square backed bubbles.

    Later on I acquired

    steveg Yesterday, 11:10 PM Go to last post
    DavidApp

    Re: Door cappingóbatting needed?

    Thank you.

    Had not got that far so I thought I would ask for some suggestions before I was at the where do we cut this bit stage.
    Like

    DavidApp Yesterday, 10:43 PM Go to last post
  • Twitter