• TR3A Scuttle Vent (air vent) Lid leveling...

    Tony's Tip #3:

    If you replace the Scuttle Vent (air vent) lid and rubber gasket on the top of the front cowl, you might find it won't be level with the ground due to the new rubber gasket being taller than original. One fix for this could be for you to fabricate and install 2-holed thin rectangular SHIMS (as required) between the new lid's hinge and the new rubber gasket, thus raising the rear of the lid so it's level with the ground. Heavy weights placed atop the lid will help set the gasket to the cowl (with the proper silicone caulking) as low as possible so the bonnet doesn't hit the front edge of the lid upon raising the bonnet.
    Comments 1 Comment
    1. badornato's Avatar
      badornato -
      level with the ground? not sure what you mean by that..
      i have a new gasket in mine and the front of the lid hits the back of the bonnet when i open it.
      very annoying.
      my simple fix is to open the scuttle before i open the bonnet..
      quirky but effective.
  • Recent Articles

  • Recent Forum Posts


    Re: Core Plug - Cam Rear change

    Yes, they are installed from the outside.

    My standard trick for removing those plugs is to drill a small hole in them, put in a self-tapping

    Sarastro Today, 03:03 PM Go to last post

    Re: Core Plug - Cam Rear change

    I wasnít going to look at this thread since Iím a TR2 guy...but I agree with the other responses. Someone installed a wrong type plug in your block.

    CJD Today, 02:54 PM Go to last post

    Re: Gear Ratios

    Thanks. If all you are doing is changing rear gears, the simplest thing to do and probably the least expensive is ship it off to Nisongers after giving

    HealeyRick Today, 02:39 PM Go to last post

    Re: Happy Valentines Day

    Probably because I accidentally deleted one of the tag brackets and typed it in again.

    catfood Today, 02:37 PM Go to last post

    Re: Gear Ratios

    Looking good HealeyRick! I too like rockin' the Healey's ivory / gold faced gauges and strive to keep things looking original.

    gonzo Today, 02:28 PM Go to last post
  • Twitter