PDA

View Full Version : Wanted Bell housing for 10" clutch with sideshift



trotti
06-20-2016, 05:09 PM
I need a bellhousing in good condition that will fit a 10" clutch that works with a sideshift. I'm not sure if the center shift bell housing is the same as side shifts.

I have a BN6 tranny in BN6 car mated to the larger BJ7 engine and flywheel.

THANKS!

mgro1959
11-23-2016, 03:56 AM
I probably have what you need. Do you have a part number just to confirm. I will check my stash. Thanks Rob

busybrit
11-23-2016, 09:00 PM
Hi, do you have a bell housing yet? You don't need one if you have the original housing that came with the BN6 transmission. This bell housing should as you know have the smaller clutch assembly fitted. The later larger clutch is 10" and won't fit,,, many will tell you.

Well it does fit, you just have to grind off the high point where the edges of the clutch housing make contact. The area is around the casting where the clutch fork protrudes. I have a photo somewhere, I'll try and dig it out.

Johnb

British_Recovery
11-24-2016, 02:09 PM
The earlier bell housing doesn't have an oil seal like the later 10" clutch version.